Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
outpost_2:helper_programs [2017/07/22 18:34] – vagabond | outpost_2:helper_programs [2017/07/26 23:35] – vagabond | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Outpost 2 Helper Programs ====== | ====== Outpost 2 Helper Programs ====== | ||
- | Below is a listing of standalone programs developed by different members of the Outpost Universe community that aid in various aspects of modifying Outpost 2. These programs were written over several years and some will not work properly | + | {{op2_sdk: |
+ | |||
+ | Below is a listing of standalone programs developed by different members of the Outpost Universe community that aid in various aspects of modifying Outpost 2. These programs were written over several years and some of the GUI programs | ||
If the program reports an error due to a missing component, check the section **Registering a Missing Component** below for troubleshooting. | If the program reports an error due to a missing component, check the section **Registering a Missing Component** below for troubleshooting. | ||
Line 17: | Line 19: | ||
| | ||
* [[outpost_2: | * [[outpost_2: | ||
- | * Check out how Outpost 2 applies Microbe and night overlay on transition tiles in a Windows based GUI. | + | * See how Outpost 2 applies Microbe and night overlay on transition tiles in a Windows based GUI. |
| | ||
* [[outpost_2: | * [[outpost_2: | ||
Line 26: | Line 28: | ||
| | ||
* [[outpost_2: | * [[outpost_2: | ||
- | * Render | + | * Render images of Outpost 2 maps using a Windows based console application. |
| | ||
* [[outpost_2: | * [[outpost_2: | ||
Line 54: | Line 56: | ||
Inside the command prompt, type or paste the command required to register the file. Comdlg32.ocx is a placeholder below, use the actual filename of the missing component you are registering. For Windows 7 x64, use the following command: | Inside the command prompt, type or paste the command required to register the file. Comdlg32.ocx is a placeholder below, use the actual filename of the missing component you are registering. For Windows 7 x64, use the following command: | ||
- | regsvr32 %Systemroot%\SysWOW64\**comdlg32.ocx** | + | < |
You will have to adjust the command for your operating system if not using Windows 7 64 bit. | You will have to adjust the command for your operating system if not using Windows 7 64 bit. |