Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
outpost_2:helper_programs [2017/07/25 14:02] – [Outpost 2 Helper Programs] vagabond | outpost_2:helper_programs [2017/07/26 23:23] – vagabond | ||
---|---|---|---|
Line 17: | Line 17: | ||
| | ||
* [[outpost_2: | * [[outpost_2: | ||
- | * Check out how Outpost 2 applies Microbe and night overlay on transition tiles in a Windows based GUI. | + | * See how Outpost 2 applies Microbe and night overlay on transition tiles in a Windows based GUI. |
| | ||
* [[outpost_2: | * [[outpost_2: | ||
Line 26: | Line 26: | ||
| | ||
* [[outpost_2: | * [[outpost_2: | ||
- | * Render | + | * Render images of Outpost 2 maps using a Windows based console application. |
| | ||
* [[outpost_2: | * [[outpost_2: | ||
Line 54: | Line 54: | ||
Inside the command prompt, type or paste the command required to register the file. Comdlg32.ocx is a placeholder below, use the actual filename of the missing component you are registering. For Windows 7 x64, use the following command: | Inside the command prompt, type or paste the command required to register the file. Comdlg32.ocx is a placeholder below, use the actual filename of the missing component you are registering. For Windows 7 x64, use the following command: | ||
- | regsvr32 %Systemroot%\SysWOW64\**comdlg32.ocx** | + | < |
You will have to adjust the command for your operating system if not using Windows 7 64 bit. | You will have to adjust the command for your operating system if not using Windows 7 64 bit. |